Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 75)

Publication 1784-UM003A-EN-P – June 2003
Configuring the1784-PM16SE Card 67
Editing 1784-PM16SE Card
Properties
General Tab Use this tab to create/view module properties for the 1784-PM16SE motion
card.
On this tab, you can:
• view the type and description of the module being created
• view the vendor of the module being created
• enter the name of the module
• enter a description for the module
• select the slot number of the module on the network
• select the minor revision number of your module
• select Exact Match, Compatible Module, or Disable Keying
Type
Displays the type and description of the module being created (read only).
Vendor
Displays the vendor of the module being created (read only).
Name
Enter the name of the card. The name must be IEC 1131-3 compliant. An
error message is displayed if you enter an invalid character or a duplicate name.
If you exceed the maximum length, the software ignores the extra characters.
Description
Enter a description for the card here, up to 128 characters. You can use any
printable character in this field. If you exceed the maximum length, the
software ignores any extra characters.