Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 442
Publication 1784-UM003A-EN-P – June 2003
434
Drive Fault Inputs
Drive Limits
Advanced Drive Limits
Maximum Positive/Negative Travel
Position Error Tolerance
Position Lock Toleranc
Drive Offsets
Friction Compensation
Torque Offset
Velocity Offset
Drive Power Attributes
Bus Regulator ID
Power Supply ID
E
Editing 1784-PM16SE Module Properties
Editing Controller Properties
Advanced Tab
Controller Fault Handler
Memory Total
Memory Unused
Memory Used
Power-Up Handler
System Overhead Time Slice
Date/Time Tab
Coordinated System Time master
Date
Set
Status
Time
File Tab
Created
Edited
Name
Path
General Tab
Change Type
Chassis Type
Description
Name
Revision
Slot
Type
Vendor
Major Faults Tab
Clear Majors
Number of Major Faults Since Last Cleared
Recent Faults
Minor Faults Tab
Clear Minors
Fault Bits
Number of Minor Faults Since Last Cleared
Recent Faults
Nonvolatile Memory Tab
Image Note
Load Image
Load Mode
Load/Store
Name
Revision
Stored
Type
Redundancy Tab
Advanced Button
Memory Usage
Retain Test Edits on Switchover
Partner Minor Faults
Partner Status
Redundancy Enabled
Redundancy Status
Serial Port Tab
Baud Rate
Continuous Carrier
Control Line
Data Bits
Mode
Parity
RTS Off Delay
RTS Send Delay
Stop Bits
SFC Execution Tab
Execution Control
Last Scan of Active Steps
Restart Position
System Protocol Tab
Active Station Tag
Common Parameters
ACK Timeout
Enable Duplicate Detection
Error Detection
Protocol
Station Address
DF1 Master Parameters
Master Transmit
Polling Mode
Reply Message Wait
Transmit Retries
DF1 Point to Point Parameters
Embedded Responses
ENQ Transmit Limit
NAK Receive Limit
DF1 Slave Parameters
EOT Suppression
Slave Poll Timeout