Editing controller properties, General tab, Vendor – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 25: Type
Publication 1784-UM003A-EN-P – June 2003
SoftLogix Controller 17
Editing Controller
Properties
The Controller Properties dialog displays controller configuration information
for the open project and, when online, for the attached controller. The Tabs
that appear are governed by the type of the selected controller. This section
describes the fields on each of the dialogs for the Controller Properties.
General Tab
The General tab displays the controller name and description, as well as the
physical properties of the controller.
Figure 2.2 Controller Properties General Tab
Vendor
Displays the name of the controller’s manufacturer.
Type
The catalog number and description of the controller. When online, this field
includes the catalog number of the memory card (if any).