Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 420)

Publication 1784-UM003A-EN-P – June 2003
412 Troubleshooting
At start up the LED goes through a sequence of color changes:
• At power up LED is Green.
• When SoftLogix driver starts the LED turns Red.
• At download of a valid program the LED is Green.
During regular operation the LED is GREEN when the Servo card is
functioning normally and RED when a fault situation occurs.
SERCOS interface LED
Indicators Checking the LED Indicators
The card provides three bi-color LED indicators to show the state of the
system. The LEDs are located on the mounting bracket of the 1784-PM16SE
card. The LED on the top, marked by OK, indicates the present health of the
card. Just below the OK LED is the SERCOS Ring Status LED. This is
marked with a ring icon and displays the status of the SERCOS network.