Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 228)

Publication 1784-UM003A-EN-P – June 2003
220 Configuring an Ultra 3000 Drive
Identification
Displays the module’s:
• Vendor
• Product Type
• Product Code
• Revision
• Serial Number
• Product Name
The name displayed in the Product Name field is read from the module. This
name displays the series of the module. If the module is a 1756-L1 module,
this field displays the catalog number of the memory expansion board (this
selection applies to any controller catalog number even if additional memory
cards are added.
Major/Minor Fault Status
Internal State Status
Displays the module’s current operational state.
• Self-test
• Flash update
• Communication fault
• Unconnected
• Flash configuration bad
• Major Fault (please refer to "Major/Minor Fault Status" above)
• Run mode
• Program mode
• (16#xxxx) unknown
If you selected the wrong module from the module selection tab, this field
displays a hexadecimal value. A textual description of this state is only given
when the module identity you provide is a match with the actual module.
If you are configuring a: This field displays one of the following:
digital module EEPROM fault
Backplane fault
None
analog module Comm. Lost with owner
Channel fault
None
Any other module None
Unrecoverable
Recoverable