Major revision, Type (list box), Description (list box) – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 56: Show, Select all, Clear all
Publication 1784-UM003A-EN-P – June 2003
48 Adding and Configuring Your 1784-PM02AE Motion Module
Major Revision
Select the major revision number of the physical module that you want in the
chassis.
The major revision is used to indicate the revision of the interface to the
module.
Type (list box)
This box lists the installed module catalog numbers based on the selected
check boxes.
Description (list box)
This portion of the list box contains descriptions of the modules.
Show
Displays check boxes, which support filtering on particular types of modules.
Select All
Click on this button to display all modules in the list box; all the check boxes in
the Show field are checked.
Clear All
Click on this button to clear all check boxes in the Show field.
4. In the Type field, select 1784-PM02AE 2 Axis Analog/Encoder Servo.
Check this box:
If you want to:
Digital
display digital modules supported by the software
Analog
display analog modules supported by the software
Communication
display communication modules supported by the software
Motion
display motion modules supported by the software
Controller
display controller modules supported by the software
Vendor
display a particular vendor's module profiles that are installed on the system.
Other
display modules that do not fit under the rest of the check box categories.