Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 46)

Publication 1784-UM003A-EN-P – June 2003
38 SoftLogix Controller
Partner Status
This section shows information on the status of the Partner module.
Mode – Shows the current state of the partner module’s mode. If the
controller does not have the redundancy feature or if it is offline, this field is
empty and the controls are disabled. Valid modes include:
• Faulted
• Run
• Program
• Test
• Unknown – Displayed for any mode that is not one of those listed
above. It also displays if the Module Compatibility is not "Fully
Compatible Partner" or "Standby Compatible Partner". Also displays
when the system is offline.
Key Switch Position – Shows the current status of the partner module’s
keyswitch position. If the controller does not have the redundancy feature or if
it is offline, this field is empty and the controls are disabled. Valid modes
include:
• Run
• Remote
• Program
• Unknown – Displays when the Module Compatibility is not "Fully
Compatible Partner" or "Standby Compatible Partner". Also displays
when the system is offline.
Key Switch Mismatch – Is activated when there is a mismatch between the
key switch position between the primary and partner modules.
Partner Minor Faults
This section shows the minor faults that are set in the partner controller. These
controls are read-only. If the controller does not have the redundancy feature
or if it is offline, the radio button is greyed and the text label is disabled. Minor
partner faults include:
• Powerup
• I/O
• Program
• Watchdog
• Serial Port
• Battery