Product name, Major/minor fault status, Internal state status – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 211: 16#xxxx) unknown, Configured, Owned
Publication 1784-UM003A-EN-P – June 2003
Configuring a 1394x-SJTxx-D Digital Servo Drive 203
Product Name
The name displayed in the Product Name field is read from the module. This
name displays the series of the module.
Major/Minor Fault Status
Statuses are: EEPROM fault, Backplane fault, None.
Internal State Status
Displays the module’s current operational state.
• Self-test
• Flash update
• Communication fault
• Unconnected
• Flash configuration bad
• Major Fault (please refer to “Major/Minor Fault Status” above)
• Run mode
• Program mode
(16#xxxx) unknown
If you selected the wrong module from the module selection tab, this field
displays a hexadecimal value. A textual description of this state is only given
when the module identity you provide is a match with the actual module.
Configured
Displays a yes or no value indicating whether the module has been configured
by an owner controller connected to it. Once a module has been configured, it
stays configured until the module is reset or power is cycled, even if the owner
drops connection to the module. This information does not apply to adapters.
Owned
Displays a yes or no value indicating whether an owner controller is currently
connected to the module. This information does not apply to adapters.