Reset module, Refresh – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 230
Publication 1784-UM003A-EN-P – June 2003
222 Configuring an Ultra 3000 Drive
Reset Module
Click on this button to return a module to its power-up state by emulating the
cycling of power.
Resetting a module causes all connections to or through the module to be
closed, and this may result in loss of control.
Note: The following modules return an error if a reset is attempted:
• 1756-L1 ControlLogix5550 Programmable Controller
• 1336T AC Vector Drive
• 1395 Digital DC Drive
Note: A controller cannot be reset.
Refresh
Click on this button to refresh the tab with new data from the module.
If you are online in Program, Remote Program or Remote Run mode, and this
controller is the owner controller, and you have changed the module’s
configuration in the software, then when you click the Apply or the OK
button, the information is automatically sent to the controller. The controller
tries to send the information to the module (if the module’s connection is not
inhibited). If you don’t click Apply, your changes are not sent to the controller.