Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 36)

Publication 1784-UM003A-EN-P – June 2003
28 SoftLogix Controller
This option is disabled when the Control Line option is configured for Half
Duplex.
Delete Mode
The character received just before the delete character sequence (0x7F) is
removed by the serial port driver before it is given to the ladder logic. Choose
from:
• Ignore - The delete character sequence is treated the same as any other
character that is read in.
• CRT or Printer - The preceding character in the string buffer is removed
before being given to the ladder logic. The only difference between CRT
and Printer modes is the type of device sending the string to the
controller. If Echo mode is disabled, CRT and Printer do exactly the
same thing.
Major Faults Tab The Major Faults tab displays information on the major faults that have
occurred in the controller.
Figure 2.8 Controller Properties Major Faults Tab