Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 24)

Publication 1784-UM003A-EN-P – June 2003
16 SoftLogix Controller
Chassis Type
Select the appropriate chassis type from the pull-down menu, shown here by
catalog number. The software uses this information to determine the number
of slots in the chassis. Depending on the controller type you chose, the
available options in this menu vary:
Slot Number
Choose the slot number where the controller resides on the backplane.
For ControlLogix controllers, the default value is 0. If the slot number exceeds
the chassis size, an error message appears, prompting you to enter a number
within the valid range.
For SoftLogix controllers, the default value is 1.
For CompactLogix, FlexLogix, and DriveLogix controllers, the value in this
field is always 0 and cannot be edited.
Revision
Enter the controller revision.
For this release of RSLogix 5000, this field is not editable. The revision
defaults to the latest revision for the given controller type.
Create In:
Enter the directory in which you want the project file to be created. The file
name is the same as the controller name, with a .acd extension.
Browse
Click on this button to bring up the Choose Directory dialog from which you
can browse for the appropriate directory.
For this platform: Choose from these chassis types:
ControlLogix 1756-A4, 4-slot ControlLogix chassis
1756-A7, 7-slot ControlLogix chassis
1756-A10, 10-slot ControlLogix chassis
1756-A13, 13-slot ControlLogix chassis
1756-A17, 17-slot ControlLogix chassis
CompactLogix Not applicable
SoftLogix 1789-17, 17-slot SoftLogix virtual chassis
FlexLogix Not applicable
DriveLogix Not applicable