Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 203)

Publication 1784-UM003A-EN-P – June 2003
Configuring a 1394x-SJTxx-D Digital Servo Drive 195
On this tab, you can:
• view the type and description of the module being created
• view the vendor of the module being created
• enter the name of the module
• enter a description for the module
• set the Base Node for the module
• select the minor revision number of your module
• select Electronic Keying (Exact Match, Compatible Module, or Disable
Keying)
• view the status the controller has about the module (you can only view
the status while online)
Type
Displays the module type of the 1394x-SJTxx-D digital servo drive module
being created (read only).
Vendor
Displays the vendor of the module being created (read only).
Name
Enter the name of the module. The name must be IEC 1131-3 compliant. If
you attempt to enter an invalid character or exceed the maximum length, the
software beeps and ignores the character.
Description
Enter a description for the module here, up to 128 characters. You can use any
printable character in this field. If you exceed the maximum length, the
software beeps to warn you, and ignores any extra characters.
Base Node
Type or select the Base Node number of the drive module. This node number
is determined by multiplying the node number from the module’s rotary switch
(1 to 9) by a factor of ten. Thus, valid Base Node values are 10, 20, 30, 40, 50,
60, 70, 80 or 90.
Revision
Select the minor revision number of your module.
The revision is divided into the major revision and minor revision. The major
revision displayed statically is chosen on the Select Module Type dialog.