Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 53)

45 Publication 1784-UM003A-EN-P – June 2003
Chapter
3
Adding and Configuring Your 1784-PM02AE
Motion Module
This chapter describes how to add, configure, and edit your 1784-PM02AE
motion module for use in your motion control application.
Adding the 1784-PM02AE
Module To use your motion module in a control system, you must add your motion
module to the application program. To add a motion module:
1. Right-click the I/O Configuration folder.
Figure 3.1 Selecting New Module from the Controller Organizer