Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 233)

Publication 1784-UM003A-EN-P – June 2003
Configuring a Kinetix 6000 Drive 225
4. Press the OK button to close the Select Module Type dialog. The
Kinetix 6000 Drive Create Wizard Module Properties dialog opens.
Figure 10.4 Module Properties Wizard Dialog - Naming the Drive
You must fill in a name for the drive; this is a required field. Fill in the
responses for the other parameters as needed, then click the Next> button to
advance to the next wizard screen or click on the Finish>> button to add the
drive.
Editing the Kinetix Drive
Properties The Module Properties for any of the Kinetix 6000 drives can be edited by
highlighting the drive to be edited, right click with the mouse and select
Properties.
Figure 10.5 Accessing the Properties of the Drive