Connection tab, Requested packet interval – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 205

Publication 1784-UM003A-EN-P – June 2003
Configuring a 1394x-SJTxx-D Digital Servo Drive 197
This feature prevents the inadvertent insertion of the wrong module in the
wrong slot.
Connection Tab
Use this tab to define controller to drive module behavior.
Figure 8.6 Module Properties - Connection Tab
On this tab, you can:
• choose to inhibit the module
• configure the controller so loss of the connection to this module causes
a major fault
• view module faults
Requested Packet Interval
This field is disabled for all motion modules (e.g., 1784-PM02AE,
1784-PM16SE, and all 1394-, Ultra3000, Kinetix 6000, and 8720 modules).
TIP
The data on this tab comes directly from the controller.
This tab displays information about the condition of the
connection between the module and the controller.