Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual - Manual (Page 83)

Publication 1784-UM003A-EN-P – June 2003
Configuring the1784-PM16SE Card 75
Fault Type
Displays the current fault type, if any, on the SERCOS ring. Values include:
• No fault
• Loss of received signal
• MST error
• Missed AT
• Excessive AT errors
• Duplicate nodes (not currently supported)
• No nodes
• Wrong ring cycle
• Wrong baud rate
• Link transport fault
• Wrong phase
• Wrong AT number
Refresh
Click this button to update this page.
Note: this information does not refresh automatically.
Module Info Tab The Module Info tab contains information about the selected card, however,
you can click on:
• Refresh – to display new data from the card.
• Reset Module – to return the card to its power-up state by emulating the
cycling of power. By doing this, you also clear all faults.
The Module Info Tab displays card and status information about the card. It
also allows you to reset a card to its power-up state. The information on this
tab is not displayed if you are offline or currently creating a card.
Use this tab to determine the identity of the card.