Stop bits, Control line, Continuous carrier – Rockwell Automation 1784-PM16SE SoftLogix Motion Card Setup and Configuration Manual User Manual
Page 29: Rts send delay, Rts off delay
Publication 1784-UM003A-EN-P – June 2003
SoftLogix Controller 21
Stop Bits
The actual number of stop bits per character. Choose from 2 (ASCII only) or 1
(default).
Control Line
Choose the type of handshaking you wish to use during communications. The
choices available to you vary, depending on the protocol you have selected:
Continuous Carrier
Check this box if you wish to use Half Duplex communication with
continuous carrier. This checkbox is disabled if you have chosen something
other than Half Duplex communication, or if you have chosen Master as your
protocol. By default, this option is unchecked when enabled.
RTS Send Delay
Enter the time (in ms) to delay transmitting the first character of a message
after turning on the RTS line. The default value is 0.
RTS Off Delay
Enter the time (in ms) to delay turning off the RTS line after the last character
has been transmitted. The default value is 0.
For this mode:
And this protocol:
Choose from:
User
ASCII
No Handshake (default)
Full Duplex
Half Duplex
System
Point-to-Point
No Handshake (default)
Full Duplex
Slave
No Handshake (default)
Half Duplex
Master
No Handshake (default)
Full Duplex
Half Duplex