Konica Minolta Digital StoreFront - Manual (Page 514)

Digital StoreFront 5.2 Administration Reference
514
10 Click Register and then click Check Status.
After you click Register, and registration succeeds:
• The Secure Communication Url will be set automatically, and should match what is in the
Configuration Url field, except for the file name which will be EFIIntegration instead of
EFIConfiguration.
• An active Pace Connect for Digital StoreFront is automatically created in the EFI Pace system,
but no events are listed for it yet. (This tells you that a communication channel was defined, but
the MIS was not registered yet.)
The next step is to configure and register the MIS on the MIS Systems page .
To change from a site certificate to an external SSL certificate
If you establish a communication channel using the default site certificate, but the Pace installation
requires SSL certificates from Digital StoreFront, you must remove the existing communication channel
and establish one based on an external SSL certificate.
1. Log into Digital StoreFront as an administrator, click the Administration tab, and go to MIS
CONFIGURATION > Manage Communication Channels. The Manage Communication Channels page
opens.
2. Click the channel you need to remove, click Unregister, and then click Delete.
3 Remove the default site certificate from the certificate store and add the external certificate:
• Open Microsoft Management Console (Start > Run > MMC).
•
Make sure the certificate generated by Digital StoreFront is deleted under Trusted Certificates
and Personal Certificates.
• Install the external SSL certificate into the Trusted Certificates section (by copying and pasting
the certificate).
4. On the Manage Communications Channel page in Digital StoreFront:
• Select External Certificate and enter the Certificate Name.
•
Select the Use SSL check box.
5 Click Register.
Verifying that Site Call Back URL Is Correct
The site call back URL is used for communication between Digital StoreFront and an MIS so you should
verify it is correct:
1 Log into Digital StoreFront as an administrator, click the Administration tab, and go to MIS
CONFIGURATION > Manage Communication Channels.
2 Verify that the Site Call Back URL field begins with the correct site URL.
If the site call back URL includes localhost, the site is being accessed on the local server using
http://localhost/Digital StoreFront (which is sometimes done for testing purposes). The site URL
is used as the base for the call back URL. When localhost is the base for a call back, however, some
communication (asynchronous) between Digital StoreFront and the MIS will not work. In this case,
you must provide access to the site from outside the domain by correcting the site URLs as
described next.