Yaskawa MP2200 Machine Controller - Manual (Page 91)

3.1 SVB-01 Module Setup
3-19
( 4 ) SVB Definitions
This section explains the method used to set the motion parameters for each axis.
[ a ] SVB Definitions Window
Use one of the following procedures to open the Module Definitions Window.
■ Opening the Motion Parameter Setting Screen (SVB Definition Window)
a) Click the Module name in the Module Details section of the Module Configuration
Window.
b) Select File – Open Slot to display the SVB Definitions Window.
■ Using the Slot Number
Double-click the slot number in the Module Details section of the Module Configuration Window to
display the SVB Definitions Window.
The following diagram shows the SVB Definitions Window.
The SVB-01 Definitions Window is composed of four tab pages: the Fixed Parameters, Set Up
Parameters, SERVOPACK, and Monitor Tab Pages.
It is possible to switch between these tab pages by selecting View − Next Page or View − Back Page
from the motion parameters window's menus.
Table 3.1 Motion Parameter Window Tab Pages
Tab Page Details
Fixed Parameters Sets the Motion Fixed Parameters.
Set Up Parameters Sets the Motion Setting Parameters.
SERVOPACK Sets the SERVOPACK Parameters.
Monitor Displays the Motion Monitoring Parameters.