Yaskawa MP2200 Machine Controller - Manual (Page 446)

8 SVR Virtual Motion Module
8.3.2 Motion Command Details
8-30
[ b ] Related Parameters
■ Setting Parameters
■ Monitoring Parameters
Parameter Name Setting
OB††000 Servo ON
Turn the power to the Servomotor ON and OFF.
1: Power ON to Servomotor, 0: Power OFF to Servomotor
Turn ON the power before setting the Motion Command (OW††08) to 7.
OW††03 Function 1 Set the speed unit, acceleration/deceleration unit, and filter type.
OW††08 Motion Command
The JOG operation starts when this parameter is set to 7. The operation will be
canceled if this parameter is set to 0 during FEED command execution.
OB††090 Command Pause This parameter is ignored for FEED command.
OB††091 Command Abort The axis is decelerated to a stop if this bit is set to 1 during JOG operation.
OB††092 JOG/STEP Direction
Set the travel direction for JOG operation.
0: Positive direction, 1: Negative direction
OL††10 Speed Reference
Specify the speed for the JOG operation. This setting can be changed during
operation. The unit depends on the setting of OW††03.
OL††36
Linear Acceleration
Time
Set the rate of acceleration of the acceleration time constant for fixed-speed feeding.
OL††38
Linear Deceleration
Time
Set the rate of deceleration of the deceleration time constant for fixed-speed feeding.
OW††3A
S-Curve Acceleration
Time
Set the acceleration/deceleration filter time constant. Exponential acceleration/
deceleration or a moving average filter can be selected in OW††03.
Change the setting only after pulse distribution has been completed for the command
(IB††0C0 is ON).
Parameter Name Monitor Contents
IB††001 Servo ON
Indicates the Servo ON status.
ON: Power supplied to Servomotor, OFF: Power not supplied to Servomotor
IL††02 Warning Stores the most current warning.
IL††04 Alarm Stores the most current alarm.
IW††08
Servo Command
Type Response Indicates the motion command that is being executed.
The response code is 7 during FEED command execution.
IB††090 Command Executing
Turns ON when abort processing is being performed for FEED command. Turns OFF
when abort processing has been completed.
IB††091
Command Hold
Completed
Always OFF for FEED command.
IB††093 Command Error End
Turns ON if an error occurs during FEED command execution. The axis will
decelerate to a stop if it is moving. Turns OFF when another command is executed.
IB††098
Command Execution
Completed
Always OFF for FEED command.
IB††0C0
Distribution
Completed Turns ON when pulse distribution has been completed for the move command.
Turns OFF during execution of a move command.
IB††0C1
Positioning
Completed
Turns ON when pulse distribution has been completed. OFF in all other cases.
IB††0C3 Position Proximity Turns ON when Distribution Completed (DEN) turns ON.