Yaskawa MP2200 Machine Controller - Manual (Page 119)

3.3 SVR Module Setup
3-47
Refer to ( 3 ) Motion Monitoring Parameters under 8.2.2 Motion Parameter Settings for details on
monitoring parameter settings.
( 3 ) Saving, Deleting, and Closing the SVR Definitions Data
Refer to ( 2 ) Module Configuration Definition Settings under 3.1.3 Module Configuration Defini-
tions.
ΠThe Delete operation deletes the motion fixed parameter and setting parameter settings of all
axes.
ΠThe edited motion fixed parameters cannot be saved if the Servo ON signal is ON. Save the
motion fixed parameters data after this signal has gone OFF.
Setting Details
Axis Number
Select the desired axis number. The parameter monitor data is displayed
in axis units.
No. Displays the parameter number for the monitoring parameter.
Name (Parameter Name) Displays the parameter name.
Reg-No.
Displays the number of the register that corresponds to the parameter
name.
The range of registers depends on the circuit number and axis number
currently being displayed. Refer to 4.1 Motion Parameters Register
Numbers.
Monitor Data
In online mode, the current values of the parameters are displayed. In
offline mode, nothing will be displayed.
Unit Displays the units of the corresponding parameter.
INFO
IMPORTANT