Grass Valley iControl V.4.43 - Manual (Page 77)

iControl
User Guide
67
Figure 2-39
The RMID page appears. By default, the Lookup Service is configured to start automatically
when the RMI (Remote Method Invocation) daemon is activated.
Figure 2-40
4. Click Start Lookup Service with RMID if you want this Application Server to run the
Lookup Service.
5. Click Do not start Lookup Service with RMID if you do not want this Application Server to
run the Lookup Service.
6. Click Accept.
Specifying Service and Alarm Discovery Locations
In order to operate iC Web on client PCs on a subnet other than the one used by the iControl
Application Server, you must add the IP address of an Application Server running a lookup
service.
IMPORTANT: The lookup service should be only activated on a maximum of two
Application Servers per subnet.
Note: The Kaleido-K2 has its own built-in lookup service which must be turned off
before it is added to an iControl network.