Grass Valley iControl V.4.43 - Manual (Page 607)

iControl
User Guide
597
Adding a Main Application Server to a Redundancy Group
To add a Main Application Server to a Redundancy Group
1. Type the IP address of the new Application Server in the box within the Main area.
2. Click Add this Main IP (next to the text field).
Figure 10-14
The Redundancy Configuration Form refreshes with the added Application Server listed
in the Main area.
Figure 10-15
3. If you would like to enable this Application Server’s Auto-failover function, in the Auto-
failover column, select Enabled in the row associated with this Application Server, and
then click Apply.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• A Redundancy Group already exists. If it does not, create the Redundancy Group
(see page 591 ).
• You have navigated to the Redundancy Configuration Form for one of the Application
Servers already belonging to this Redundancy Group (see page 712 ).
Note: If you would like the Auto-failover function to remain disabled for this
Application Server, clear the Enabled check box, and then click Apply.