Grass Valley iControl V.4.43 - Manual (Page 628)

Backup and Redundancy
Engaging Failover
618
Engaging Failover
To engage failover
• Select Engage Failover from the Remote Control Monitoring and Pilot Control area
(lower right area of the Web page).
The button becomes grayed out to indicate that it is active.
Figure 10-44
Changing the Signal Path from the Backup to the Main using the Matrix
Application
After completion of an Engage Failover, the following procedure explains how to return the
signal path from the backup to the main.
The following image shows the signal path from the main to the backup as it should be after
completion of the procedure.
Note: The following procedure includes steps that use the iControl Router Manager
For details about iControl Router Manager configuration, see the iControl Router
Manager Quick Start Guide.
IMPORTANT: The following Failover procedure is applicable only if your iControl Web site
offers Failover functionality.