Grass Valley iControl V.4.43 - Manual (Page 184)

Logs
Creating an Incident Template from the GSM Alarm Browser
174
5. If required, select Create a new incident even if there is no fault. Doing so creates an
incident even if none of the alarms specified in the selection are in a fault status.
6. Click OK.
Creating an Incident Template from the GSM Alarm Browser
To create an Incident Template using the Alarm Browser
1. In the GSM Alarm Browser, select one or more nodes from the Alarm Browser’s tree.
2. Right-click one of the selected nodes and click Create incident template.
Note: For a given incident template, there can only be one incident open at a time.
Once the open incident is cleared, the template can be triggered at any time by a
subsequent alarm, whereupon a new incident (with a new ID) will be opened.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened the GSM Alarm Browser (see "Opening the GSM Alarm Browser" , on
page 732).