Grass Valley iControl V.4.43 - Manual (Page 310)

Access Control
Setting up Access Control
300
Figure 6-3
Here are the steps you would follow to set up Access Control in this scenario, along with
references to the associated procedures in this chapter:
To set up Access Control in the preceding example
1. Activate LDAP service — Log on to the Webmin utility on an Application Server
(e.g. Alpha), and use the Access Control Configuration Form to set up and activate an
LDAP service, including building a list of managed domains and remote domain referrals (if
any).
See page 306
2. Enable access control — Use the Access Control Configuration Form to enable access
control on Alpha.
See page 314 .
3. Configure users, roles, and permissions — Open iC Navigator from Alpha, and then use
the Privilege Management window to create users, assign roles (e.g. operator, admin), and
assign permissions (e.g. ability to open a control panel). Then open iC Creator and use the
Page Privilege Management window to assign Web-based permissions (e.g. ability to
open a Web site).
See "Opening the Privilege Management Window" , on page 708