Grass Valley iControl V.4.43 - Manual (Page 174)

Logs
Adding a Custom Timestamp Column to the Results Table
164
Figure 4-78
The column appears in the results table.
Adding a Custom Timestamp Column to the Results Table
You can add a custom timestamp column to the results table of either Incident Log Viewer or
Events Log Viewer.
Adding a Custom Timestamp Column to Incident Log Viewer
To add a custom timestamp column to Incident Log Viewer
1. In Incident Log Viewer, right-click anywhere on the header row of the results table, point
to Add other columns, and then click Custom timestamp.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened either Event Log Viewer or Incident Log Viewer as required
(see "Opening Event Log Viewer" , on page 721 and "Opening Incident Log Viewer" , on
page 724).