Grass Valley iControl V.4.43 - Manual (Page 322)

Access Control
Configuring the LDAP Service on an iControl Application Server for Multiple Domains
312
14. Select the Run LDAP service on this Application Server check box.
As the LDAP service starts up, the Webmin page reloads.
15. In the Domains Managed Here section, click Add.
A window appears, prompting you to type domain name.
16. Type the local domain name (from ), and then click OK.
The newly added local domain appears in the list under Domains Managed Here.
17. Repeat as needed to add additional domains.
At this point, the LDAP service is running and configured on both the local and the referral
Application Servers. You should also enable Access Control on these servers if this has not
already been done (see
page 314 ).
Note: If you configured the LDAP service immediately after enabling Access
Control on the Application Server, you must now restart iControl (see
"Starting &
Stopping iControl Services" , on page 697 of the iControl Basics chapter).