Grass Valley iControl V.4.43 User Manual
Page 430
Alarms in iControl
Inverting Alarms Manually
420
4. If you would like to invert only one alarm, right-click the appropriate alarm, point to
Operational mode, and then select (or clear) Inverted, as required.
Figure 7-100
The associated alarm’s Inverted mode is set to On (or to Off, depending on your inversion
action).
5. If you would like to invert more than one alarm, perform the following steps:
a) Click the first alarm you would like to invert.
b) Hold down the Ctrl key and individually click the remaining alarms.
c) Release the Ctrl key.
d) Right-click one of the selected alarms, and then click All inverted (or None inverted,
as required).
Note: All inverted inverts all selected alarms. Non inverted reverts all selected
alarms’ Inverted modes to Off.