Grass Valley iControl V.4.43 - Manual (Page 352)

Alarms in iControl
Alarm Types
342
not reset until the alarm condition goes away. Latches are system wide and all clients see the
same latch.
Figure 7-1: Resetting individual alarm’s latch
Figure 7-2: Resetting alarm latches of all alarms in an alarm folder
Alarm Types
There are a number of different types of iControl alarms, described briefly below and in
greater detail later in this chapter. The diagrams on the following pages show how the various
alarm types appear in iControl.
Virtual Alarms
A virtual alarm is a special type of alarm that allows you to derive a new result from the
status(es) of one or more existing alarms.
See also
For more information, see:
• "Alarm Components" , on page 346
• "Latches, Acknowledgment and Virtual Alarms" , on page 355
• "Resetting Latches on Web Pages" , on page 412