Grass Valley iControl V.4.43 - Manual (Page 567)

iControl
User Guide
557
Configuring Fingerprint Analyzer Service Alarms
The Fingerprint Analysis feature uses alarms to communicate comparison data to a user in
real-time. You can configure the following parameters of Fingerprint Analyzer Service alarms:
• Alarm severity sent to the GSM (GSM contribution)
• Whether to log events
To configure Service alarms
1. On the Configuration tab, in the Fingerprint comparison setup area, click Alarm config.
Sample workflow: Initial configuration tasks
1. Enable the Audio/Video Fingerprint Analyzer Service on the Webmin page of your
Application Server (see
"Starting & Stopping iControl Services" , on page 697).
2. Open Audio Video Fingerprint Analyzer (see page 739 ).
3. Configure Fingerprint Analyzer Service alarms according to your individual needs
(see
page 557 ).
4. Create a comparison group of input sources, including a reference source (see page 558 ).
5. Assign all desired input sources (including the reference source) to your comparison group
(see
page 561 ).
6. Designate one of the assigned sources as the Reference (see "Configuring a Source as the
Reference Source in a Comparison Group" , on page 565).
7. Configure each assigned source’s channel assignments, as required (see "Changing a
Source’s Channel Assignments" , on page 567).
REQUIREMENT
Before beginning this procedure, make sure you have opened Audio Video Fingerprint
Analyzer (see
page 739 ).