Grass Valley iControl V.4.43 - Manual (Page 62)

Getting Started with iControl
Connecting to a New iControl Application Server
52
Figure 2-23: Rear view of R310 Application Server, showing logical ports eth0 and eth1 (physical ports Gb1
and Gb2, respectively)
Figure 2-24
2. Open a browser window on the client PC.
3. In the address field, type 10.0.3.6 (this is the default IP address of the iControl Application
Server).
The iControl Startup page appears.
Note: The default IP address and subnet mask settings for the Application Server
when shipped from the factory are shown on a sticker on the top cover of the chassis
above the front-panel power switch. The factory default is
10.0.3.6 .
Gb1 Gb2