Grass Valley iControl V.4.43 - Manual (Page 72)

Getting Started with iControl
Restarting the Application Server
62
The values you type should be based on the IP address and the desired network
configuration. In the above example (
10.10.80.10 ), the corresponding netmask has been
configured as 255.255.255.0 , with a resulting broadcast address of 10.10.80.255 . You
should always verify these values with a network administrator.
6. Leave the MTU field blank.
7. Select Yes next to Activate at boot.
8. Click Save.
9. Return to the Network Configuration page by clicking the Return arrow at the bottom of the
Network Interfaces page.
Restarting the Application Server
Once you have specified all the settings your Application Server needs to be able to operate
on your local network, you must restart the system to apply the new configuration.
To restart the Application Server
1. On the Webmin home page, click Bootup and Shutdown.
Note: If you do not select Yes, the eth0 interface resets to its previous values the
next time the system restarts.
Notes
• Clicking Save does not update the Application Server with the new
configuration. To apply your changes, you still need to click Apply
Configuration on the Network Configuration page or restart the system
through Webmin (see
"Restarting the Application Server" , on page 62).
• The Application Server’s eth0 port is set to auto-negotiate, full duplex mode
by default. This setting should not be changed. The network switch to which
the Application Server is connected should also be set to auto-negotiate to
avoid data packet loss.
IMPORTANT: Do not click Apply Configuration on the Network Configuration page.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You are logged on to iControl Webmin (see page 701 ).
• You have performed step 1 through step 4 of "Configuring the Network" , on page 55.