Grass Valley iControl V.4.43 - Manual (Page 518)

iControl and SNMP
Configuring iControl to Generate SNMP Traps for All Alarms
508
Figure 8-119
Configuring iControl to Generate SNMP Traps for All Alarms
To configure iControl to generate SNMP traps for all/any alarms
1. In the GSM Alarm Browser, click the Admin tab, and then click the Actions tab..
Note: The SNMP OIDs specific to Miranda devices and to the iControl GSM agent
and traps are contained in MIB files (
GSM‐MIB.mib and the MIRANDA‐MIB.mib )
available from Miranda Technical Support (see "Contact Us" , on page 761).
WARNING: Depending on the scale of your GSM-visible alarm footprint, performing this
procedure may have a detrimental impact upon iControl, a destination
SNMP manager, or general network performance. Care should be taken when
configuring GSM SNMP agents for all alarms.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened the GSM Alarm Browser (see "Opening the GSM Alarm Browser" , on
page 732).