Control panel tabs, Device info – Grass Valley iControl V.4.43 User Manual
Page 249

iControl
User Guide
239
Control Panel Tabs
The table below lists examples of typical control panel tabs and their associated parameters:
The control panel for some devices contains a Load Factory button. Click this button to reset
the device parameters in the active tab to their original factory values.
Device Info
The Info tab of a control panel displays general information
related to a device, and is available for all device types. The
Info tab includes identification information such as a
device’s label, short label, type, comments, source ID,
configuration status, frame number, and slot number.
TIP: To quickly display the Info tab for a device, right-click the
device in iC Navigator, and then click Show info control
panel.
Under the Info tab, you can change the name of the
selected device, as well as enter comments. By default, the
device name is its type identification. However, you may find
it helpful to give devices more meaningful names. Once you
change the device name in the control panel, the name of
the item is also changed in the iC Navigator display, making
it easier to locate.
You can also register a device with the lookup service on a
remote Application Server using Remote system administration.
Note: If you encounter the message
Control Panel Not Available
, it means that
your selection has not been implemented as a controllable device in iControl. You
can view the status of such a device, but you cannot modify any of its parameters.
Tab
Sample Parameters
Config
Audio Destination, Audio Source, Audio Delay, No Signal Delay, Signal
Standards Detection, No Signal Delay, Scan, VBI, Video
Info
Comments, Device Type, Label, Long ID, Manufacturer, Remote System
Administration, Service Version, Short Label, Source ID, Vendor
Video
Player, Thumbnail Streaming, Streaming Priority Control, Waveform Monitor
and Vector Scope.
Timing
Horizontal Fine, Horizontal Position, Horizontal Timing, Vertical Timing, Fine
Timing Adjustments
Meta
Aspect Ratio, Copy Control Information, Source