Grass Valley iControl V.4.43 - Manual (Page 172)

Logs
Sorting Rows in Incident Log Viewer
162
To sort the found rows in Event Log Viewer
1. In Event Log Viewer, click the header of the column you wish to sort.
A down arrow or up arrow appears beside the header title.
2. Click again on the column header to toggle the sort order.
Sorting Rows in Incident Log Viewer
Sorting in Incident Log Viewer is the same as in Event Log Viewer, with the following
exception:
You can click any column header to toggle the sort order from up to down based on that
column’s data. Click a different column header to sort by a different criterion.
Adding, Removing & Repositioning Columns
Adding a Column to the Results Table in Event Log Viewer
To add a column to the results table of Event Log Viewer
• In Event Log Viewer, on the Columns menu, point to Add other columns, and then click
on a column selection.
Figure 4-76
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened Event Log Viewer (see page 721 ).
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened either Event Log Viewer or Incident Log Viewer as required
(see "Opening Event Log Viewer" , on page 721 and "Opening Incident Log Viewer" , on
page 724).