Grass Valley iControl V.4.43 - Manual (Page 173)

iControl
User Guide
163
OR,
Right-click anywhere in the results table, point to Add other columns, and then click on a
column selection.
Figure 4-77
The column appears in the results table.
Adding a Column to the Results Table in Incident Log Viewer
To add a column to the results table of Incident Log Viewer
• In Incident Log Viewer, right-click anywhere in the column header row of the results table,
point to Add other columns, and then click on a column selection.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iC Navigator (see page 719 ).
• You have opened either Event Log Viewer or Incident Log Viewer as required
(see "Opening Event Log Viewer" , on page 721 and "Opening Incident Log Viewer" , on
page 724).