Grass Valley iControl V.4.43 - Manual (Page 583)

iControl
User Guide
573
Figure 9-33
The names of the comparison group and its sources are no longer bolded, indicating that
the comparison has ended.
Monitoring Fingerprint Comparison Data
Once a lip-sync or motion detection comparison has been initiated, you can monitor the
analysis results in real-time, either as status alarms in the GSM Alarm Browser or on the Status
tab of Audio Video Fingerprint Analyzer. You can also view events in Event Log Viewer:
• "Monitoring Comparison Data with Audio Video Fingerprint Analyzer" , on page 573
• "Monitoring Comparison Data in the GSM Alarm Browser" , on page 574
Monitoring Comparison Data with Audio Video Fingerprint Analyzer
To monitor comparison data with Audio Video Fingerprint Analyzer
1. In Audio Video Fingerprint Analyzer, click on the Status tab.
2. Use the vertical scroll bar (if there is one) to scroll down to the area corresponding to the
comparison group whose data you would like to view.
Note: If the signal format changes on any of the compared cards during a
comparison, there may be a delay of 15 to 20 seconds before comparison data
resume updating. This applies to status updates on both the GSM Alarm Browser and
Audio Video Fingerprint Analyzer.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl Navigator (see page 719 ).
• Your comparison group already exists and is configured (see "Creating a New
Comparison Group" , on page 558).
• You have initiated a comparison between the reference source and one or more probed
sources (see "Starting a Fingerprint Comparison" , on page 571).
• You have opened Audio Video Fingerprint Analyzer (see page 739 ).