Grass Valley iControl V.4.43 User Manual
Page 610
Backup and Redundancy
Removing an Application Server from a Redundancy Group
600
Figure 10-19
7. Click Apply.
The Redundancy Configuration Form refreshes displaying the new replication frequency.
Removing an Application Server from a Redundancy Group
To remove an Application Server from a Redundancy Group
1. On the Redundancy Configuration Form, identify the Application Server you would like
to remove in either the Main area or the Backup area.
2. Click Remove in the Removal column of the row corresponding to the Application Server
you are removing.
Note: You can view the last time the Main Application Server was replicated on the
Redundancy Configuration Form of the Backup Application Server, in the Last
replication result column. Initially, there will be no timestamp because the Backup
initiates its first replication after the Main has been added. If a replication is in
progress, then Running will be displayed.
IMPORTANT: System behavior
Regardless of the configured replication frequency, the system performs a
replication immediately following any change in the Redundancy
Configuration Form.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• A Redundancy Group already exists with associated Application Servers.
• You have opened iControl for any Application Server belonging to the Redundancy
Group (see
• You have navigated to the Redundancy Configuration Form for the Application Server
mentioned in the requirement before this one (see
).