Grass Valley iControl V.4.43 - Manual (Page 374)

Alarms in iControl
Configuring iControl Navigator to View Alarms with Specific Operational Modes
364
A confirmation window appears.
Figure 7-22
2. Click Yes.
The page reloads and all alarms currently in In maintenance mode (or Offline, or both,
depending on what you specified in
step 1 ) will reveal their actual status (e.g. alarms that
were dark red will appear red). The words In maintenance (or Offline , or both) will appear
at the right side of the status bar.
Configuring iControl Navigator to View Alarms with Specific Operational
Modes
To set the view of an operational mode in iC Navigator
• On the View menu of iC Navigator, point to Operational mode, and then click Offline or
In maintenance (or both) as required:
There are several different system behaviors that occur depending on how you have
configured iControl to display alarms.
Note: An operational mode view only applies for the particular client session where
it was enabled. The view of other users remains unaffected.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened iControl (see page 696 ).
• You have opened iControl Navigator (see page 719 ).