Grass Valley iControl V.4.43 User Manual
Page 252
Configuring Devices & Services
Sorting
242
order. Ungrouped items are displayed at the end of the list. Empty slots are not shown,
unless they are in the Reference Configuration.
• Physical view arranges devices relative to their physical connections and network
location. It shows the iControl Application Server itself, and the frames, cards and other
devices connected to it via Ethernet or serial ports. Empty slots show up as
empty
, unless
the card is designated as
In Ref Config
, in which case it will show up as before, but with
the description
missing from slot
.
All Miranda frame slots are shown, even if they are empty. Devices are sorted by:
•
the IP address of the iControl Application Server with which they are associated,
•
then, for Miranda Imaging frames, by the serial communication port of the Application
Server to which the frame is connected, or, for Miranda Densité frames, by the frame’s
IP address
•
then, within a frame, by slot number.
• Flat view shows all devices in alphabetical order without any grouping.
Figure 5-3
Note: Logical grouping information is stored on the Application Server. Any
changes to the device groupings will be visible to all users.
Note: In Logical view and Physical view, you can open and close folders in the list
by clicking on the [+] or [–] box beside the folder.
See also
For more information about:
• the Reference Configuration, see
• adding a device to the Reference Configuration, see
• removing a device from the Reference Configuration, see