Grass Valley iControl V.4.43 - Manual (Page 497)

iControl
User Guide
487
Publishing a Driver
To publish an SNMP driver
• In the SNMP Driver Creator window, type the IP address of the device, and then click
Publish alarms.
Figure 8-84
The alarms are published.
Editing Procedures
You can edit a driver’s configuration with the following procedures:
• "Editing an Alarm" , on page 487
• "Editing a Driver’s Generated Script" , on page 488
• "Editing an Alarm Map, Trap Map, or Poller Profile" , on page 489
Editing an Alarm
To edit an alarm
1. In SNMP Driver Creator, in the Alarms list, select the alarm you would like to edit, and then
click Edit.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 737 ).
• you have loaded a MIB module into SNMP Driver Creator (see page 462 ).
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 737 ).
• You have loaded a MIB module into SNMP Driver Creator (see page 462 ).
• You are displaying the Alarms tab in SNMP Driver Creator.
• You have configured your driver settings (see page 467 ).