Replacing an application, Server in a redundancy group – Grass Valley iControl V.4.43 User Manual
Page 625
iControl
User Guide
615
The Network Interfaces page appears.
Figure 10-40
8. Click eth0.
9. The Edit Bootup Interface page appears.
Figure 10-41
10. Change the eth 0 port’s IP address for this Application Server to the same IP address you
typed in
.
11. Click Save.
12. Click Return to network configuration.
13. Click Apply Configuration.
The Application Server reboots. When the Reboot process is complete, the Application
Server will have the new IP address.
14. If required, add this Application Server to the Redundancy Group (see
Replacing an Application Server in a Redundancy Group
Note: This procedure is applicable only if the Take over the main IP address after
failover check box is selected (on the Redundancy Configuration Form). If this
check box was cleared when an Auto-failover or Manual Takeover occurred, you will
need to perform the procedure