Grass Valley iControl V.4.43 - Manual (Page 271)

iControl
User Guide
261
Figure 5-31
Removing a Proc Amp DeviceRemoving a Proc Amp Device
To remove a proc amp device from your system
• In the iC Navigator window (Logical view), right-click the proc amp device that you wish
to remove, and click Destroy.
The selected proc amp device disappears.
Creating a Composite Panel
Composite Panels are a new type of virtual service for controlling two or more cards with a
single GUI. While intended primarily for Densité series cards, some older Imaging series cards
are also supported.
Composite Panels can contain certain dashboard elements (e.g. input signal, reference), global
audio and video alarms (if supported by the card), video processing elements, audio
processing elements, and user presets. You can create up to 50 Composite Panels per
Application Server
There are three steps involved in creating a Composite Panel: component selection,
configuration, and initialization.
To create a Composite Panel
1. Open the iControl Services Monitoring and Configuration page in Webmin (see "Starting &
Stopping iControl Services" , on page 697). Make sure the Virtual Service Manager is active
(green).
Figure 5-32
Audio processing
controls from audio
card(s)
Dashboard elements
from each card
Video processing
controls from video card
Click here to identify
the cards this panel is
controlling
Virtual
Service
Manager
active