Creating a trap map – Grass Valley iControl V.4.43 User Manual
Page 485
iControl
User Guide
475
3. Click on one of the options in the Mapping type area.
4. For each mapping rule you would like to add, perform the following substeps:
a) Click Add to generate an instance of the mapping rule template.
An unconfigured mapping rule appears in the Mapping rules list.
b) In the row corresponding to the new mapping rule, click and configure each cell.
Figure 8-60
5. Click OK.
The new map appears in the Alarm maps area of the Alarms tab in SNMP Driver Creator.
Figure 8-61
Creating a Trap Map
There are several ways in which you can create a trap map. The differences lie in the way in
which you navigate to the Create Alarm Map window.
Notes
• In the case of the Operator and GSM status columns, you must click once.
In the case of the MIB value and GSM text columns, you must double-click.
• Depending on which cell you click, either select from one of the listed
options or type the desired value to configure the parameter.
See also
For more information about editing an existing alarm map any time after it has been
created, see