Grass Valley iControl V.4.43 User Manual
Page 71
iControl
User Guide
61
To configure the Ethernet interface
1. On the Network Configuration page, click Network Interfaces.
The Network Interfaces page appears. This page shows all Ethernet interfaces currently
active, and lists those that will be activated any time the system is booted.
Figure 2-34
2. Click eth0 in the Name column.
The Edit Bootup Interface page appears.
Figure 2-35
3. Select Static.
4. In the field to the right of the Static option button, type the fixed IP address you would like
to use for this iControl Application Server.
5. Type addresses in the Netmask and Broadcast fields that correspond to your desired
network configuration.
Note: This page shows the current settings for the eth0 interface, which are the
factory default values if you are configuring this port for the first time.
IMPORTANT: Make sure you type the IP address exactly as it is on the Edit Host Address
page (see
of
Note: Typically the IP addresses for all devices on a LAN will begin with the same
two data groups, and the remaining two will be assigned by the system
administrator.