Grass Valley iControl V.4.43 - Manual (Page 63)

iControl
User Guide
53
Figure 2-25
Ethernet Port Labeling on the R210 and R310 Application Servers
The physical Ethernet ports on the backs of the Dell PowerEdge R210 and R310 are labeled
as Gb1 and Gb2. The physical (cabling) port called Gb1 corresponds to logical (Webmin)
port eth0. Likewise, the physical port called Gb2 corresponds to logical port eth1.
Throughout this document, when speaking of cabling and physical ports, the physical port
numbers will match the logical port numbers, which is true for all types of Application Servers
except the R200, R210, and R310. In the case of the R200, R210, and R310, you must map
according to the table below. For example, if a procedure instructs you to connect a cable to
an Application Server’s eth0 port, you must connect the cable to the R210’s physical port
labeled Gb1.
Notes
• iC Router Control, iC Web and iC Creator are optional, and will only appear on
the iControl Startup Page if you purchased the corresponding options.
• If your Web browser cannot find the Application Server, make sure the PC’s
network settings are correct (see "Preparing a PC for Configuring the
Application Server" , on page 45).