Grass Valley iControl V.4.43 - Manual (Page 499)

iControl
User Guide
489
Figure 8-87
The Script editor appears in the main pane.
Figure 8-88
2. Modify the JavaScript code directly or if you would like to add a script OID getter or script
variable getter, perform the procedure "Adding an OID Getter and Variable Getter from a
MIB Module" , on page 481.
3. Use the Check Syntax function to verify your code as required (see page 491 ).
Editing an Alarm Map, Trap Map, or Poller Profile
You can edit alarm map, trap map, and poller configuration data after an initial configuration is
performed. The following procedure details steps for an alarm map. However, the procedures
for editing trap maps and pollers are principally the same.
REQUIREMENTS
Make sure you meet the following conditions before beginning this procedure:
• You have opened SNMP Driver Creator (see page 737 ).
• You have loaded a MIB module into SNMP Driver Creator (see page 462 ).
• You are displaying the Alarms tab in SNMP Driver Creator.
• You have configured your driver settings (see page 467 ).
• The alarm map you would like to edit is visible in the Alarm maps area on the Alarms
tab of the SNMP Driver Creator.