Grass Valley iControl V.4.43 - Manual (Page 69)

iControl
User Guide
59
6. Return to the Network Configuration page by clicking the Return arrow at the bottom of the
Host Addresses page.
Specifying a Network Gateway
In order for an Application Server to be able to send to (or receive data from) devices outside
its own subnet, it must use a network gateway.
To specify a network gateway to be used by the iControl Application Server
1. On the Network Configuration page, click Routing and Gateways.
The Routing and Gateways page appears.
Figure 2-33
2. Select eth0 from the Interface list in the Default Routes area.
Note: Clicking Save does not update the Application Server with the new
configuration. To apply your changes, you still need to click Apply Configuration on
the Network Configuration page or restart the system through Webmin
(see
"Restarting the Application Server" , on page 62).
IMPORTANT: Do not click Apply Configuration on the Network Configuration page.
REQUIREMENT
Before beginning this procedure, make sure you have navigated to the Network
Configuration page of Webmin (see
page 55 ).