Grass Valley iControl V.4.43 User Manual
Page 613
iControl
User Guide
603
c) In this same cell, click Go.
Figure 10-23
When the page next attempts to refresh (or when you manually click the Refresh button) it
will be unable to retrieve data because the configured Backup no longer has a current
IP address.
3. Wait about 1 minute.
4. In your browser’s address bar, type the Extra IP address (noted in
) to connect to the
taken-over configured Main (now Offline).
5. Navigate to the Redundancy Configuration Form (see
).
Figure 10-24: Redundancy Configuration Form after Manual Takeover (taken-over, configured Main
circled)
6. If you observe the following, the manual takeover was a success:
In the row corresponding to the taken-over configured Main (now Offline):
•
the color of the row is yellow
•
the Current IP is the same as the configured Extra IP (or the factory default IP:
10.0.3.6
if no Extra IP is configured)